hab mir beim China mann den Controller hier geholt.
Jetzt hab ich Probleme den korrekt anzuschließen.
Motor und Hallsensor hab ich bereits dran.
Wo ist hier den der Anschluss für den Gasgriff?
Der ein und auschalter der am Gas griff drann ist.
Der Anschluss für die 3 Stufen Regleung.
Vielen Dank für eure hilfe.
Miro
•
Rated Voltage: 48 Volts
•
power: 1000 Watts
•
Suitable for 3 phase 60° or 120° brushless motor.
•
Suitable for Electric for electric bike & scooter
•
Under Voltage Protection: 42 V±0.5v
•
Maximum Current: 40 A±1Amps
•
Usable Motor: 48V 700-1000 Watts
•
Operating Conditions: -40℃～80℃
•
Waterproof design
wiring instructions:
The power cord：big red +big black- - - -
Electric Door Lock Cable: middle red
The motor cable: big yellow+ big green+ big blue
The hall cable: the small red cable, the small black cable, the small yellow cable, the small green cable, the small blue cable
The transfer cable：the small red cable（+5V）+the small blue cable （Signal）+the small black cable（Negative electrode）
The three-speed cable：blue (high speed )+black +gray(low speed)
The high level brake: yellow cable
The low level brake :yellow+ black cable
Anti-theft features：red（positive）+black（negative）red(electric start)+blue(Lock motor signals) +green(lock motor)
EBS electric brake: two blue cables matched
Cruise function: two Gray cables connecting together.
Self-learning cable:white two cable with black plug (after Positive rotation,then disconnect)
Installation instruction:
1 Power cut off before connects wires, connect the wires according to wiring diagram shown.
2 The controller should be installed in ventilation, waterproof, shockproof parts
3 Controller speed-limit control plug should be placed in easy operation place
4 The controller connectors should be plugged in place to prohibited the controller power supply positive and negative reverse (ie.coarse red, thin orange and coarse black; thin red and thin black reversed is strictly prohibited)
5 Motor mode automatically recognizes: the right to access the power of the electric vehicle controller, and turn to the brake lever and other harness, the docking of the controller will be learning lines (white), open the electric door locks, make motor into the state of the automatic identification, if motor reverse rotation can turn the motor forward rotation, disconnect the motor mode can be completed automatically recognize directly in the controller to identify motor mode 10 seconds after the controller to indentify learning lines (white).
